Next Time I do this I'll submit pictures
I can't quite visualize where you used a tooth pick. Although I understand about the lifetime supply of grease, I use more than a toothpick full to grease the barrel shaped ferrel on the end on the cable, and pivot pin and bushing.
Once I take the lever off I pull the little barrel (13) off the end of the cable and cover it with grease. Then put it back on to the cable. Then put the cable and barrel on to the lever, then lever back into position, slide the (greased)pivot bushing (5) and Greased pivot pin (4) into the bracket and carefully tighten the nut (7) on the Pivot pin.
Then wipe everything down and adjust the play inthe cable.
Does that make sense now that you've done it?
See attached drawing.
|