Vision - Mirror Post size?

[John Ritter]

Hello Everyone,
wondering if anyone knows the Mirror post size on the Vision?

Am looking to get a Ram Mount ball(s) and don't know if they sent the wrong size, or the size doesn't match the hole?

I ordered:
RAM M10 X 1.25 Pitch Male Thread with 1" Ball

http://www.ram-mount.com/CatalogResults/PartDetails/tabid/63/partid/082065077045066045051052057085/Default.aspx

They only had 2 sizes, the one above and a 3/8".


Have seen them around on other bikes, and took for granted it was about a M10? Is it?


When I checked Polaris, they had them here (but noted it was for an 09:
http://www.purepolaris.com/en-us/Victory/Pages/Detail.aspx?ItemID=2877371%28PolarisPGACatalog%29&prevfitment=cup

[Sparky_Bill]

Google. victory vision ram ball

The ones I had on my 09 fit just fine on my 11

[flatsboy]

John,

This is from Vision-Riders.com:

"Posted 2011-08-08 5:30 PM (#92935 - in reply to #92931)
Subject: Re: what size are your balls?

Tourer

Posts: 568

Location: Northern Illinois - The tapped holes in the left and right reservoirs on the '09 and up Visions are 10mm, the Victory accessory mount that replaces the lower clamp on either side is tapped with 3/8-16NC threaded holes. The two different threads are incompatible."

Is this correct? If not I have a new:

Part ID: RAM-B-239U

UNPKD. 1" RAM BALL WITH 5/16"-18 POST

You're welcome to it if it works for your application

[John Ritter]

I found the issue:

The correct size is 10M X 1.25 pitch - just as both websites state.

What RAM sent was 10M X 1.50 pitch

I have emailed them to get their resolution and the correct ones.

Stay tuned!